Frameless Shower Door Seal Placement: Where Water Usually Escapes
Frameless shower doors usually leak for the same handful of reasons: the seal is in the wrong place, the door is out of plumb, the threshold slopes the wrong way, or water is escaping at the hinge ...
How to Check Whether a Tub Ledge Is Wide Enough for a Glass Door
A tub ledge that looks “wide enough” can still fail once you add glass, wall finish, and hardware clearance. Start with the finished ledge width, not the old tub label or the rough opening. For mos...
2026 Bathroom Remodel Checklist: What to Finalize Before Ordering Shower Glass
Ordering shower glass before the bathroom is fully finalized is where a lot of remodels get expensive. The opening can look right on paper and still miss once tile thickness, out-of-plumb walls, cu...
Pivot Shower Door Sweep Gap: How Much Is Normal?
Pivot shower door sweep gap is normal only when it is small, even, and still keeps water inside the shower. A thin daylight line at the bottom edge can be acceptable if the door closes cleanly and ...
Shower Base Replacement Without Moving the Drain: What Must Match?
Replacing a shower base without moving the drain sounds simple until the new pan fits the footprint but misses the rough-in. The drain location, curb height, and finished opening all have to line u...
Wet Room Glass Panel Planning: Floor Slope, Drain Position, and Splash Zones
Wet room glass panel planning starts with the floor, not the glass. If the slope sends water toward the entry, a fixed panel alone will not save the room, and a drain that looks centered on paper m...
Black Shower Door With Dark Tile: How to Avoid a Heavy Look
Black shower door hardware against dark tile can look sharp, but it can also make a shower opening feel visually dense if the proportions are wrong. The usual fix is not to avoid black altogether. ...